Why the Order You Clean in Matters More Than the Product You Use
Most kennel cleaning problems come down to sequence, not choice of product. Apply disinfectant to a surface that still has organic material on it and you are wasting both money and effort. Faeces, urine residue, fur, and food debris all interfere with disinfectant chemistry. The active ingredients bind to organic matter before they reach the bacteria and viruses you are trying to kill, which means the contact time passes without the surface being properly sanitised.
This matters most for canine parvovirus. The Kennel Club notes that parvovirus can survive on contaminated surfaces for up to nine months, and concrete is one of the surfaces where it persists longest. A product application without a thorough pre-clean first will not reliably eliminate it. The sequence is: remove waste, pre-clean with detergent, rinse, apply disinfectant, allow contact time, rinse again, dry completely. That order is not a preference; it is how the chemistry works.
This guide covers the full daily and deep-clean process for both home kennel owners and licensed boarding operators. Where the two audiences need different standards, the article says so clearly.
What You Need Before You Start
Gather everything before the dog leaves the kennel. Stopping mid-clean to find a brush or more water breaks the protocol and increases the risk of tracking contamination between areas.
- Rubber gloves and waterproof boots (non-porous surfaces prevent cross-contamination)
- Protective eyewear for pressure washing or chemical handling
- Stiff-bristle scrubbing brush or deck brush
- Squeegee
- Hosepipe or pressure washer
- Pet-safe detergent for the pre-clean stage
- Kennel disinfectant (choose a virucidal and bactericidal product; see our guide to choosing the right kennel disinfectant for approved options including vet and kennel disinfectants and how dilution ratios work)
- Separate buckets for detergent wash and disinfectant solution
- Clean bedding, towels, or a washing machine nearby
A note on product selection: the UK statutory guidance for licensed boarding kennels under the Animal Welfare (Licensing of Activities Involving Animals) (England) Regulations 2018 specifies that disinfectants must be virucidal as well as bactericidal. This applies to licensed operators, but the same logic applies at home. A product that kills bacteria but not viruses is not adequate where parvovirus or kennel cough is a concern. For a detailed breakdown of DEFRA-approved kennel disinfectants and how to compare active ingredients, contact times, and dilution rates, the dedicated disinfectant guide covers all the main options. For what makes a good kennel environment in the first place, the dog kennel guide covers structure, materials, and design.
Daily Cleaning Routine
Daily cleaning for a single-dog home kennel is a 10-minute job if the kennel was set up with hygiene in mind. The goal is not a full disinfection every day; it is removing the waste and contamination that builds up overnight before it becomes a bigger problem.
Morning Spot Clean
- Remove the dog and any loose items (bedding, toys, bowls).
- Scoop and bag all solid waste immediately.
- Check the floor and walls for urine marks or mud. Wipe down with a damp cloth and diluted kennel cleaner solution.
- Empty and rinse the water bowl. Refill with fresh water.
- Rinse food bowl and replace with fresh food.
- Shake out or replace bedding if it is damp or soiled.
- Return the dog once the kennel is dry.
For licensed boarding operators, the 2018 Regulations require faeces to be removed a minimum of twice daily from all areas. Morning and early evening removal is the standard approach in most compliant facilities. A brief visual inspection of the kennel structure (checking latches, flooring condition, and drainage) is worth building into the morning routine as well.
The Deep Clean Process
A deep clean applies a full disinfection cycle to every surface in the kennel. For a home kennel with a single dog in good health, once a week is the standard. For licensed boarding facilities, the Regulations require disinfection at every occupancy change and at least once weekly regardless of occupancy.
Total time: approximately 30 to 45 minutes depending on kennel size. Allow additional drying time before the dog returns.
Step 1: Remove the Dog and All Loose Items
The dog must not be present during any cleaning involving disinfectant. Place the dog in a secure, covered area away from the kennel. Remove all items: bedding, bowls, toys, raised beds, and any accessories. These are cleaned separately (see Step 8).
Step 2: Remove Solid Waste and Debris
Bag and dispose of all solid waste. Sweep or scrape the floor to remove loose fur, mud, and food debris. Pay attention to corners and along the base of walls where debris collects. A stiff broom works well on concrete; for plastic flooring, a rubber broom avoids scratching the surface.
Step 3: Pre-Clean with Detergent (The Step Most People Skip)
Apply a pet-safe detergent solution to all surfaces: walls, floor, gate, and any fixed fittings. Scrub with a stiff brush from top to bottom and left to right to avoid re-contaminating areas you have already cleaned. Rinse with clean water. The surface should look clean before disinfectant goes on. If you can still see residue or smell urine, scrub again.
This step is the one most home kennel owners omit, and it is the reason their disinfectant does not perform as the label suggests. ProVetLogic’s published guidance on disinfectants versus organic matter explains that organic material significantly reduces disinfectant efficacy by binding active ingredients before they reach pathogens. The detergent pre-clean removes that barrier.
Step 4: Apply Kennel Disinfectant
Mix the disinfectant to the manufacturer’s dilution ratio. For routine disinfection, most QAC-based kennel disinfectants dilute at 1:20 to 1:100 depending on the product and the task (see the product label; do not guess). Apply from top to bottom: upper walls first if the kennel is enclosed, then walls, then floor. Use a pump sprayer for even coverage, or a mop and bucket for floor-only applications.
Do not dilute more than instructed. More water means less active ingredient per square metre; it does not make the product safer for surfaces or animals.
Step 5: Allow Contact Time
Contact time is the period the disinfectant must remain wet on the surface to achieve its stated kill rate. Most kennel disinfectants specify 10 minutes. Do not rinse early. If the surface dries before the contact time is up, re-apply. Contact time is not a guideline; it is the mechanism by which the product achieves its efficacy claims.
Step 6: Rinse Thoroughly
Rinse all surfaces with clean water, starting from the top and working down. The rinse removes disinfectant residue. Even pet-safe products should not remain on surfaces the dog will contact after drying. Use a squeegee to push excess water toward the drain. Check that drainage channels are clear; standing water from cleaning or urine is a compliance failure for licensed operators and a hygiene risk for home kennels.
Step 7: Dry Completely Before Returning the Dog
The kennel must be dry before the dog returns. Wet surfaces carry disinfectant residue and re-wet the bedding immediately, reducing its insulating value and creating conditions for bacterial growth. In warm weather, air drying after squeegeeing takes 20 to 30 minutes. In cold or humid conditions, a leaf blower or portable fan speeds this up considerably. Do not return the dog to a damp kennel.
There is a difference between the surface being touch-dry and fully dry through any concrete. If the floor was heavily wetted, allow longer. Echo’s kennel has a concrete floor, and I’ve found the walls and floor are properly dry within 30 minutes in summer, but closer to an hour on cold Scottish mornings. Worth accounting for that in your timing.
Step 8: Clean Bowls, Bedding, and Toys Separately
Food and water bowls should be washed with hot water and detergent, rinsed, then disinfected and rinsed again before returning to the kennel. For licensed boarding facilities, bowls must be disinfected between different dogs. Bedding goes in the washing machine at 60°C, which is the temperature cited in veterinary guidance for killing kennel pathogens. Toys should be inspected for damage at this point and cleaned with disinfectant solution or replaced if they cannot be adequately sanitised.
How Often Should You Clean a Dog Kennel?
Frequency depends on occupancy, the dog’s health status, and whether the kennel is a single-dog home setup or a multi-dog boarding facility.
| Task | Home Owner (Single Dog) | Licensed Boarding Operator |
|---|---|---|
| Waste removal | Once daily minimum | Twice daily minimum (statutory) |
| Spot clean and bowl refresh | Daily | Daily (each occupied kennel) |
| Full deep clean with disinfection | Weekly | Weekly minimum; at every occupancy change |
| Bedding wash | Weekly or when soiled | Between dogs; not reused across occupancies |
| Toy and enrichment item clean | Weekly | Weekly; or between dogs if shared |
If a dog has been unwell, shown symptoms of an infectious condition, or come from a source with a known disease concern, increase the deep clean frequency and use a disinfectant with confirmed virucidal action rather than a basic cleaner. The PDSA’s guidance on kennel cough notes that the bacteria involved can survive on surfaces for days, which means the kennel environment needs addressing alongside the dog’s treatment.
Between-Dogs Protocol for Licensed Operators
This section applies to anyone operating under an animal activity licence in England under the Animal Welfare (Licensing of Activities Involving Animals) (England) Regulations 2018. If you board dogs for other owners commercially, even from home, you need this licence and must meet these standards.
The statutory requirement for kennel cleaning between dog occupancies covers several specific obligations:
- The kennel must be fully cleaned and disinfected before admitting the next dog. The full deep clean process above applies; a quick wipe-down does not meet the standard.
- Disinfectant products must be virucidal as well as bactericidal. A product stating “kills 99.9% of bacteria” does not necessarily meet this requirement. Check the product data sheet for confirmation of virucidal action.
- All bedding must be replaced. Bedding from one occupancy cannot be reused for the next dog.
- Food and water bowls must be disinfected between dogs.
- Toys and enrichment items must be cleaned and disinfected or returned to the previous dog’s owner.
- No standing water is acceptable post-cleaning. Drainage must be cleared and functioning.
The between-dogs protocol is where many small operators fall short. The deep clean takes 30 to 45 minutes per kennel unit. If dogs depart and arrive on the same day, that turnaround time needs to be built into the booking schedule. An inspector who finds a kennel that has not been through the full protocol between occupancies has grounds for a licence review.
The GOV.UK statutory guidance for dog kennel boarding licensing details the full cleaning obligations, and the DEFRA disinfectants register lists products approved for use in licensed premises. Searching for products listed for General Orders use is a reliable starting point for operators checking compliance.
Cleaning by Floor Type
The kennel flooring material affects both how you clean and how effectively the surface can be sanitised. For a full breakdown of flooring options, drainage, and which surfaces are easiest to maintain over time, the kennel flooring guide covers each type in depth.
Concrete
Concrete is durable and drains well when correctly laid with a fall toward a drain. It is porous without a sealant, which means pathogens and odours can embed in the surface over time. Sealed or epoxy-coated concrete is significantly easier to disinfect. For unsealed concrete, increase scrubbing time in the detergent stage and consider a longer disinfectant contact period. Parvovirus can survive in porous concrete for several months; thorough pre-cleaning is non-negotiable on this surface.
Wipe-Clean Plastic Flooring
High-density plastic kennel flooring is non-porous and resists absorption, making it the easiest surface to disinfect. Standard cleaning applies: detergent pre-clean, rinse, disinfectant, contact time, rinse. Avoid abrasive brushes that scratch the surface; micro-scratches create harbourage points for pathogens. The overview of kennel types and construction explains how wipe-clean flooring fits into the overall kennel design and welfare assessment.
Timber
Untreated timber is not suitable for kennel interiors that contact waste directly. It absorbs moisture and cannot be adequately disinfected. If your kennel has a timber interior, applying a pet-safe wood sealant that makes the surface non-porous is the minimum step to bring cleaning up to standard. Painted or sealed timber can be cleaned like any other surface, but requires regular inspection for peeling or cracks where contamination can harbour.
Frequently Asked Questions
Can I Use Bleach to Clean a Dog Kennel?
Bleach (sodium hypochlorite) is effective against parvovirus at a 1:32 dilution with water. The concern is residual toxicity: bleach is harmful to dogs if surfaces are not thoroughly rinsed and dried before reoccupation. It also degrades certain plastics and rubber over time. Purpose-made kennel disinfectants based on QAC compounds or accelerated hydrogen peroxide are generally safer and equally effective when used at the correct dilution. If you use bleach, rinse twice and allow full drying before the dog returns.
How Long Does a Kennel Need to Dry Before the Dog Can Return?
The surface must be touch-dry with no standing water or pooled disinfectant residue before the dog re-enters. In practice, this means 20 to 30 minutes in warm weather with good drainage, up to an hour in cold or humid conditions. The dog’s bedding should be dry too; damp bedding placed on a damp floor negates the cleaning you just completed.
Does the Deep Clean Frequency Change If My Dog Has Been Ill?
Yes. If your dog has had an infectious condition such as kennel cough, parvovirus, or gastroenteritis, treat the kennel as a contaminated environment. Deep clean immediately after the illness, use a virucidal disinfectant confirmed to work against the specific pathogen involved, and increase the cleaning frequency until the dog has been clear of symptoms for at least a week. Consult your vet if you are unsure whether the kennel environment could be a reinfection source.
Do I Need a Special Cleaning Routine for Kennel Cough?
The bacteria responsible for kennel cough (Bordetella bronchiseptica) can survive on surfaces and in the environment for days to weeks. Standard deep-clean protocol with a QAC or hydrogen peroxide-based disinfectant with confirmed bactericidal action handles this. The most important step is the detergent pre-clean: kennel cough bacteria in dried respiratory secretions need mechanical removal before disinfectant can reach them effectively.